From: Jensen, Brian D. (bdjensen@eschelon.com)
Date: Tue Dec 12 2006 - 18:58:13 ART
Hi Tony,
Actually you can, in earlier versions of ACS as well as 4.0, just source
each from different loopback interfaces, and create separate entries in
your ACS server for each one. I have this set up currently for dialup,
TACACS for device management, and Radius for user authentication. Works
great!
Thanks,
Brian J.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Tony Schaffran
Sent: Tuesday, December 12, 2006 2:03 PM
To: 'Alec'; 'Group Study'
Subject: RE: ACS using both Radius & Tacacs+ simultaneously
Unless it has changed in version 4.0, that is not possible.
You can only have one entry for each network device and it needs to be
configured as a TACACS or RADIUS client, not both.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Alec
Sent: Tuesday, December 12, 2006 9:15 AM
To: Group Study
Subject: ACS using both Radius & Tacacs+ simultaneously
Hi all,
I noticed that some ACS features require Radius eg downloadable acl's
while other features require Tacacs+ eg command accounting.
If I wanted to use both features but only had a single ACS server
would that be possble?
If so, how would I configure a single ACS to run both Tacacs+ and
Radius simultaneously?
Thanks in advance
---------------------------------
Everyone is raving about the all-new Yahoo! Mail beta.
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:37 ART