Re: Can't see rooute table from stub

From: nagendra kumar (nagendranainar@yahoo.co.in)
Date: Tue Dec 12 2006 - 07:59:34 ART

• Next message: Ivan: "Re: IEWB ver 3 Volume 2 Lab3 Task 3.1"
• Previous message: Ian Blaney: "Re: BGP Peering failed due to jitter"
• Maybe in reply to: Liu_Liao: "Can't see rooute table from stub"
• Next in thread: Liu_Liao: "Re: Can't see rooute table from stub"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Liu,
           Can you give us the config info. Have you configured e0 in any area ?. If not, have you redistributed in ospf domain?. I ahve a similar setup in my topo and able to see R3's s0 in R1 routing table.
  
  Regards,
  Nagendra

Liu_Liao <liu_liao@yahoo.com.tw> wrote: Hi All

<--(s0)R1(s1)<-->(s0)R2(s1)<-->(s0)R3(e0)->
R1(s0) area 0
R1(s1) and R2(s0) area 2
R2(s1) and R3(s0) area 3

R1 and R2 configure area 2 virtual-link

R2
area 3 stub no-summary

R3
area 3 stub

I can't see the route table of R3(s0) and R3(e0), so I can't ping the R1's loopback ip.
R3 have default fron ospf.

Tks

Richard

• Next message: Ivan: "Re: IEWB ver 3 Volume 2 Lab3 Task 3.1"
• Previous message: Ian Blaney: "Re: BGP Peering failed due to jitter"
• Maybe in reply to: Liu_Liao: "Can't see rooute table from stub"
• Next in thread: Liu_Liao: "Re: Can't see rooute table from stub"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:37 ART