Re: OSPF Stub and Default

From: nagendra kumar (nagendranainar@yahoo.co.in)
Date: Fri Dec 08 2006 - 01:42:09 ART

• Next message: Scott Morris: "RE: Protected Ports"
• Previous message: Salman Abbas: "Re: Protected Ports"
• Maybe in reply to: Liu_Liao: "OSPF Stub and Default"
• Next in thread: Liu_Liao: "Re: OSPF Stub and Default"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

HI Liu,
        Try creating a virtual link between R2 and R1. R2 is an ABR and it doesnt have any OSPF interface in backbone area (Area 0). Configuring a virtual link between R1 and R2 will solve your problem..
  
  Regards,
  Nagendra

Liu_Liao <liu_liao@yahoo.com.tw> wrote: Hi All,
<--(s0)R1(s1)<-->(s0)R2(s1)<-->(s0)R3(e0)->
R1(s0) area 0
R1(s1) and R2(s0) area 2
R2(s1) and R3(s0) area 3
R2 only should advertise an OSPF default route into Area 3
I configure the stub both R2 and R3 and I can't see the default route
from R2.
How to do?

• Next message: Scott Morris: "RE: Protected Ports"
• Previous message: Salman Abbas: "Re: Protected Ports"
• Maybe in reply to: Liu_Liao: "OSPF Stub and Default"
• Next in thread: Liu_Liao: "Re: OSPF Stub and Default"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:37 ART