From: Anderson Mota Alves (mota_anderson@hotmail.com)
Date: Sun Dec 03 2006 - 13:01:46 ART
Hi Rodrigo,
This is the default behaviour of the ODR technology itself from my point of
view.
Basically what you need to do in order for this to work properly is on the
hub router you need to enable ODR routing protocol using the command "router
odr" and then you need to use the command under the odr routing level
"network YY.YY.0.0" to send it to the spokes..
After that enable cdp under the serial interface on the hub router and also
enable it under the serial on the spoke router side facing the hub router,
that's all you need to do and you will see on the spokes routers that the
hub will be sending them a default route..
After that in case you need the another routers from another routing
protocol to be able to reach the spokes (the odr ones) just proceed with a
redistribution on the hub router from odr to the other routing protocol.
Cheers,
Anderson
>From: "Rodrigo Cesine Soave" <rcesine@terra.com.br>
>Reply-To: "Rodrigo Cesine Soave" <rcesine@terra.com.br>
>To: <ccielab@groupstudy.com>
>Subject: ODR default Routing Date: Sat, 2 Dec 2006 18:17:48 -0200
>
>Hi everyone,
>
>I was trying to find the feauture mentioned on the ODR Q&A document, but I
>couldn4t.
>
>Has everyone know about how send a default routing in a ODR environment
>from
>the Hub to the spokes without using static routes or ip default-gateway on
>the
>spokes?
>
>I did not find any new feature on the cisco web page.
>
>Tks in advance.
>
>
>Check below the document:
>
>Do I need to configure a static default route in spoke routers?
> A. You can configure a static default route in spoke routers only if you
>are
>using a Cisco IOS Software release earlier than 12.0.5T. In Cisco IOS
>Software
>Release 12.0.5T and later, there is a new feature that sends an automatic
>default route to spokes from the hub.
>
>_______________________________________________________________________
>Subscription information may be found at:
>http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:36 ART