From: WorkerBee (ciscobee@gmail.com)
Date: Fri Dec 01 2006 - 00:06:21 ART
1) shut
2) encap fr
3) no frame-relay inverse
4) when all other hub/spokes are done for step 1,2 and 3 then "no shut" for all
I have no problem with this method because the moment you enable
encap fr with the interface unshut and if there is ip address configured,
inverse arp will take place immediately before u can hit "no fr inverse-arp"
On 12/1/06, Iamgoingtobeaccie Iamgoingtobeaccie
<heyiamgoingtobeaccie@yahoo.co.in> wrote:
> Guys,
> When I configure frame-relay with main interfaces,I often see maps to 0.0.0.0. I know thats a problem and I save the config and reload the routers to remove them.
>
> How would I prevent them from appearing.I follow the below method.
>
> 1)encap frame
> 2)no frame inv
> 3)no sh(I make sure I bring up the interface only after disabling inverse ARP)
>
> Inspite of this,maps to zeroes are seen in 'show frame map' output.
>
> Is there a better practise to prevent this.Should I bring up the interface of a router only after I disabled Inverse ARP in all of the frame relay routers.
>
> thanks
>
>
> ---------------------------------
> Find out what India is talking about on - Yahoo! Answers India
> Send FREE SMS to your friend's mobile from Yahoo! Messenger Version 8. Get it NOW
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jan 02 2007 - 07:50:36 ART