From: Iamgoingtobeaccie
Date: Thu Nov 30 2006 - 23:56:13 ART
Guys,
When I configure frame-relay with main interfaces,I often see maps to 0.0.0.0. I know thats a problem and I save the config and reload the routers to remove them.
How would I prevent them from appearing.I follow the below method.
1)encap frame
2)no frame inv
3)no sh(I make sure I bring up the interface only after disabling inverse ARP)
Inspite of this,maps to zeroes are seen in 'show frame map' output.
Is there a better practise to prevent this.Should I bring up the interface of a router only after I disabled Inverse ARP in all of the frame relay routers.
thanks
---------------------------------
Find out what India is talking about on - Yahoo! Answers India
Send FREE SMS to your friend's mobile from Yahoo! Messenger Version 8. Get it NOW
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:49 ART