From: Dishan Gamage (dishanlg@gmail.com)
Date: Tue Nov 28 2006 - 02:19:56 ART
cheers!!! , its works now...
kind reg
dishan
On 11/28/06, Scott Morris <swm@emanon.com> wrote:
>
> Well... Neither router has an "ipv6 address" command corresponding to
> your
> unicast global address there, so it doesn't see it in its routing table to
> begin with. Maps are nice, but an L3-L2 lookup happens AFTER your routing
> table lookup will.
>
> "show ipv6 route" may help
> "debug ipv6 packet" would always be good to watch too.
>
> HTH,
>
>
> Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
> #153, CISSP, et al.
> CCSI/JNCI-M/JNCI-J
> IPExpert VP - Curriculum Development
> IPExpert Sr. Technical Instructor
> smorris@ipexpert.com
> http://www.ipexpert.com
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Dishan Gamage
> Sent: Monday, November 27, 2006 10:33 PM
> To: Aaron Pilcher; Cisco certification
> Subject: Re: Ipv6 over Frame-relay
>
> Hi Aaron,
>
> Pls hav a look at my config
>
>
> I have R5 connected to R2 and R6 via FR
>
>
> R5 config ------>
>
> interface Serial0/0/0.265 multipoint
> ipv6 address FE80::5 link-local
> frame-relay map ipv6 2111:256:256:256::6 506 broadcast
> frame-relay map ipv6 FE80::2 502 broadcast
> frame-relay map ipv6 FE80::6 506 broadcast
> frame-relay map ipv6 2111:256:256:256::2 502 broadcast
>
>
> R2 config ---->
>
> interface Serial0/0/0
> encapsulation frame-relay
> ipv6 address FE80::2 link-local
> clock rate 128000
> frame-relay map ipv6 FE80::5 205 broadcast
> frame-relay map ipv6 2111:256:256:256::5 205
> no frame-relay inverse-arp
>
> when i ping from R5 to R2 its unreachable
>
> any wrong config that i hav made ????
>
>
> pls advise
>
> reg
> dishan
>
>
>
>
>
> On 11/28/06, Aaron Pilcher <apilcher@itgcs.com> wrote:
> >
> > Easy stuff.....there is no inarp for ipv6 yet so you have to map both
> > the global and link locak addresses....
> >
> > Hope that is an easy fix for ya
> >
> > Aaron #17168
> >
> > -----Original Message-----
> > From: "Dishan Gamage" <dishanlg@gmail.com>
> > To: ccielab@groupstudy.com
> > Sent: 11/27/2006 11:17 AM
> > Subject: Ipv6 over Frame-relay
> >
> > Hi group
> >
> > can any one point out a good url, doc, that shows how to configure
> > ipv6 over FR pls..
> >
> > reg
> >
> > dishan
> >
> > ______________________________________________________________________
> > _ Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:48 ART