From: haducbinh (haducbinh@vnpro.org)
Date: Sun Nov 26 2006 - 00:34:34 ART
So, when should we use peer-policy and peer-session?
Thank you Ivan!
HaDucBinh
Mail: haducbinh@vnpro.org or haducbinh@gmail.com
Phone: +84 908 191 322
---------------------------------------------------------------------------
Vietnamese Professionals (VnPro)
Cisco Authorised Training
149/1D Ung Van Khiem Street, Ward 25, Binh Thanh District, Ho Chi Minh City
Tel: (08) 5124257 - (08) 5125314
Fax: (08) 5124314
Website: http://vnpro.vn
Support Forum: http://vnpro.org
-----Original Message-----
From: Ivan [mailto:ivan@iip.net]
Sent: Saturday, November 25, 2006 7:00 PM
To: ccielab@groupstudy.com; haducbinh
Subject: Re: BGP Templete
Surfing through DocCD result me to peer-policy has command that applied
inside
addess-family to concrete one. As for peer-session has general configuration
keyword wich applied to common session parameters.
The same you can see from sh ip bgp nei command peer-session immediately
after
neighbor definition (in example SESS) and peer-policy after defining Address
Family (in example below POL)
Router#sh ip bgp neighbors 1.1.1.1
% BGP cannot run because the router-id is not configured
BGP neighbor is 1.1.1.1, remote AS 3216, external link
Inherits from template SESS for session parameters
BGP version 4, remote router ID 0.0.0.0
BGP state = Idle
Last read 00:16:25, last write 00:16:25, hold time is 180, keepalive
interval is 60 seconds
Message statistics:
InQ depth is 0
OutQ depth is 0
Sent Rcvd
Opens: 0 0
Notifications: 0 0
Updates: 0 0
Keepalives: 0 0
Route Refresh: 0 0
Total: 0 0
Default minimum time between advertisement runs is 30 seconds
For address family: IPv4 Unicast
BGP table version 1, neighbor version 0/0
Output queue size : 0
Index 0, Offset 0, Mask 0x0
0 update-group member
Inherits from template POL
On Saturday 25 November 2006 11:19, haducbinh wrote:
> Hi GS!
>
> I see 2 options in configuration BGP templete:
>
> R1(config-router)#template ?
>
> peer-policy Template configuration for policy parameters
>
> peer-session Template configuration for session parameters
>
> please show me what is difference between them! I try to configure
> "templete peer-session" replace for "peer-group"
>
> but I don't know what "template peer-policy" use for?
>
>
>
> Thanks!
>
> HaDucBinh
> Mail: <mailto:haducbinh@vnpro.org> haducbinh@vnpro.org or
> haducbinh@gmail.com
>
> Phone: +84 908 191 322
>
---------------------------------------------------------------------------
> Vietnamese Professionals (VnPro)
> Cisco Authorised Training
> 149/1D Ung Van Khiem Street, Ward 25, Binh Thanh District, Ho Chi Minh
City
> Tel: (08) 5124257 - (08) 5125314
> Fax: (08) 5124314
> Website: <http://vnpro.vn> http://vnpro.vn
> Support Forum: <http://vnpro.org> http://vnpro.org
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
-- Ivan
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:48 ART