From: Jens Petter (jenseike@start.no)
Date: Tue Nov 14 2006 - 19:58:55 ART
The interface on the sup dont have the media type command there
L3-Core#1(config-if)#media?
% Unrecognized command
The interface have no specially sfp commands as I can see either :
Mvh
Jens Petter Eikeland
Mob 98247550
Hipercom AS
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Tony
Schaffran
Sent: 14. november 2006 21:20
To: 'Jens Petter'; ccielab@groupstudy.com
Subject: RE: regarding cat 4500 switches
Does this interface on the sup have the option of an SFP or an RJ45 Ethernet
port?
If so, you need to set the medial type on the interface to use the SFP.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Jens
Petter
Sent: Tuesday, November 14, 2006 10:51 AM
To: ccielab@groupstudy.com
Subject: regarding cat 4500 switches
I have interconected two 4503 switches using SFP Modules in the SFP
interfaces on the supervisor modul. I am not able to get link, I have tried
with default
setting on the interface although this is the current. Regardles of this
config, I should get the link here, but I am not.
Any tips of what I need to do here, I cant seem to figure this out.
interface GigabitEthernet1/19
no switchport
no ip address
channel-group 1 mode on
!
on a show interface I see that no traffic what so ever have been recived or
sent here.
L3-Core#1#sh int g1/19
GigabitEthernet1/19 is down, line protocol is down (notconnect)
Hardware is Gigabit Ethernet Port, address is 0018.187a.5fff (bia
0018.187a.5fff)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, Auto-speed, link type is auto, media type is 1000BaseSX
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
L3 in Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
L3 out Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Mvh
Jens Petter Eikeland
Mob 98247550
Hipercom AS
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:47 ART