From: Victor Cappuccio (vcappuccio@desca.com)
Date: Sun Nov 12 2006 - 03:26:55 ART
Hi,
When configuring PPP over Frame-relay using P2P subinterfaces, does the
Virtual-Access has a Queue?
It the same applies for PPP Over Frame-relay using Multipoint interfaces
(physical or not)?
Many Thanks
Victor.-
R1#show queueing interface virtual-template 1
Interface Virtual-Template1 queueing strategy: none
R1#show queueing interface virtual-access 1
Interface Virtual-Access1 queueing strategy: none
R1#show queue virtual-tem 1
'Show queue' not supported with FIFO queueing.
R1#show queue virtual-access 1
'Show queue' not supported with FIFO queueing.
R1#conf ter
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#policy-map TEST
R1(config-pmap)#class class-default
R1(config-pmap-c)#shape avera 8000
R1(config-pmap-c)#exit
R1(config-pmap)#int virtual-temp 1
R1(config-if)#serv out TEST
R1(config-if)#^Z
R1#show queueing interface virtual-access 1
Interface Virtual-Access1 queueing strategy: none
R1#show queueing interface virtual-template 1
Interface Virtual-Template1 queueing strategy: none
R1#show queue virtual-tem 1
'Show queue' not supported with FIFO queueing.
R1#show queue virtual-access 1
'Show queue' not supported with FIFO queueing.
R1#conf ter
Enter configuration commands, one per line. End with CNTL/Z.
R1(config-pmap)#policy-map TEST
R1(config-pmap)#class class-default
R1(config-pmap-c)#fair
%FR-PPP: Only FIFO queuing is allowed for virtual access
R1(config-pmap-c)#do show queueing int virtual-temp 1
Interface Virtual-Template1 queueing strategy: none
R1(config-pmap-c)#do show queueing int virtual-acc 1
Interface Virtual-Access1 queueing strategy: none
R1(config-pmap-c)#do show queue virtual-tem 1
'Show queue' not supported with FIFO queueing.
R1(config-pmap-c)#do show queue virtual-access 1
'Show queue' not supported with FIFO queueing.
R1(config-pmap-c)#do show policy-map int virtual-acc 1
Virtual-Access1
Service-policy output: TEST
Class-map: class-default (match-any)
12 packets, 192 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: any
Traffic Shaping
Target/Average Byte Sustain Excess Interval
Increment
Rate Limit bits/int bits/int (ms) (bytes)
8000/8000 2000 8000 8000 1000 1000
Adapt Queue Packets Bytes Packets Bytes Shaping
Active Depth Delayed Delayed Active
- 0 12 192 0 0 no
R1(config-pmap-c)#
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:46 ART