From: Frank (ocsic@web.de)
Date: Thu Nov 09 2006 - 07:44:14 ART
Ivan schrieb:
Ah, i have seen what you mean.
Rack1SW2#sh vtp st
VTP Version : 2
Configuration Revision : 0
Maximum VLANs supported locally : 1005
Number of existing VLANs : 10
VTP Operating Mode : Transparent
VTP Domain Name :
VTP Pruning Mode : Enabled
VTP V2 Mode : Disabled
VTP Traps Generation : Disabled
MD5 digest : 0x59 0x0E 0x33 0x72 0x94 0xC8 0xF9 0xDF
Configuration last modified by 156.1.8.8 at 3-1-93 03:30:43
Rack1SW2#vtp prun
Cannot modify pruning unless in VTP server mode
Rack1SW2#
But pruning is enabled. If i enable pruning first and then set it to
transparend it's
still turned on.
Frank
> VTP-message spread across VTP-domain. Empty VTP-domain usually need to
> autoconfigure switch to existing VTP-domain in current network.
>
> In your dump SW1 in Server mode not in transparent.
>
> On Thursday 09 November 2006 12:48, Frank wrote:
>
>> Ivan schrieb:
>>
>> Hi,
>>
>> ok. That means, i don't have to set a vtp domain to have pruning. By
>> default switches are
>> set to server without domain.
>>
>> So if i don't change them, pruning will be possbile. If i change both
>> switches to transparent
>> pruning will not be able even if enabled? How do i verify this?
>>
>> I set both to transparent:
>>
>> Rack1SW1#sh vtp st
>> VTP Version : 2
>> Configuration Revision : 0
>> Maximum VLANs supported locally : 1005
>> Number of existing VLANs : 12
>> VTP Operating Mode : Server
>> VTP Domain Name :
>> VTP Pruning Mode : Enabled
>> VTP V2 Mode : Disabled
>> VTP Traps Generation : Disabled
>> MD5 digest : 0x45 0x26 0x0B 0xF2 0xA6 0x03 0x3E 0x5B
>> Configuration last modified by 156.1.7.7 at 3-1-93 03:30:29
>> Local updater ID is 156.1.7.7 on interface Vl7 (lowest numbered VLAN
>> interface found)
>>
>> Rack1SW1#sh int pru
>>
>> Port Vlans pruned for lack of request by neighbor
>> Po1 none
>>
>> Port Vlan traffic requested of neighbor
>> Po1 none
>>
>>
>>
>> Frank
>>
>>
>>> To enable VTP pruning need to enable only on VTP-server. Therefore
>>> VTP-domain must be operatable.
>>>
>>> On Thursday 09 November 2006 10:31, Frank wrote:
>>>
>>>> Hi,
>>>>
>>>> i have a question about vtp and pruning.
>>>>
>>>> Is it necessary to set a vtp domain to be able to do pruning?
>>>>
>>>>
>>>> Frank
>>>>
>>>> _______________________________________________________________________
>>>> Subscription information may be found at:
>>>> http://www.groupstudy.com/list/CCIELab.html
>>>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:45 ART