From: Ivan (ivan@iip.net)
Date: Thu Nov 09 2006 - 07:26:28 ART
VTP-message spread across VTP-domain. Empty VTP-domain usually need to
autoconfigure switch to existing VTP-domain in current network.
In your dump SW1 in Server mode not in transparent.
On Thursday 09 November 2006 12:48, Frank wrote:
> Ivan schrieb:
>
> Hi,
>
> ok. That means, i don't have to set a vtp domain to have pruning. By
> default switches are
> set to server without domain.
>
> So if i don't change them, pruning will be possbile. If i change both
> switches to transparent
> pruning will not be able even if enabled? How do i verify this?
>
> I set both to transparent:
>
> Rack1SW1#sh vtp st
> VTP Version : 2
> Configuration Revision : 0
> Maximum VLANs supported locally : 1005
> Number of existing VLANs : 12
> VTP Operating Mode : Server
> VTP Domain Name :
> VTP Pruning Mode : Enabled
> VTP V2 Mode : Disabled
> VTP Traps Generation : Disabled
> MD5 digest : 0x45 0x26 0x0B 0xF2 0xA6 0x03 0x3E 0x5B
> Configuration last modified by 156.1.7.7 at 3-1-93 03:30:29
> Local updater ID is 156.1.7.7 on interface Vl7 (lowest numbered VLAN
> interface found)
>
> Rack1SW1#sh int pru
>
> Port Vlans pruned for lack of request by neighbor
> Po1 none
>
> Port Vlan traffic requested of neighbor
> Po1 none
>
>
>
> Frank
>
> > To enable VTP pruning need to enable only on VTP-server. Therefore
> > VTP-domain must be operatable.
> >
> > On Thursday 09 November 2006 10:31, Frank wrote:
> >> Hi,
> >>
> >> i have a question about vtp and pruning.
> >>
> >> Is it necessary to set a vtp domain to be able to do pruning?
> >>
> >>
> >> Frank
> >>
> >> _______________________________________________________________________
> >> Subscription information may be found at:
> >> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
-- Ivan
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:45 ART