From: srdja blagojevic (srdja1@pexim.co.yu)
Date: Sun Nov 05 2006 - 01:44:08 ART
I guess that you did not "cathc it" with route-map conn on R3.
Can you post this route-map config?
Srdja
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
shank shank
Sent: Saturday, November 04, 2006 14:52
To: CCIE Group
Subject: redistribution question
all,
i have the following setup R2-------Eigrp-----R3----ospf-----R5
i have
used the netwrok command to advertise the loopback 0 interface into ospf
area 0 on R3. i alsodid mutual redistribtion between ospf and Eigrp. the
problem is that i see all routes between the two protocols. except for the
loopback of
R3 that does not show on R2. to clarify i do see all other routes from ospf
domanin on R2 except the loopback of R3. and i see all routes from eigrp
form
R2 on R3. this is the configs:
R2
router eigrp 100
network 150.9.2.2 0.0.0.0
network 183.9.2.2 0.0.0.0
network 183.9.123.2 0.0.0.0
network 183.9.0.0
no
auto-summary
eigrp router-id 150.9.2.2
R3
router eigrp 100
redistribute
connected route-map conn
redistribute ospf 1 metric 1 1 1 1 1
network
183.9.123.3 0.0.0.0
no auto-summary
eigrp router-id 150.9.3.3
!
router ospf
1
router-id 150.9.3.3
log-adjacency-changes
redistribute eigrp 100
network
150.9.3.3 0.0.0.0 area 0
network 183.9.0.3 0.0.0.0 area 0
any reason why?
shanky,
thanks
This archive was generated by hypermail 2.1.4 : Fri Dec 01 2006 - 08:05:45 ART