From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Wed Oct 25 2006 - 07:18:05 ART
Is the VTP the part that you are having an issue with? If so, take a
look at the revision under the show vtp status. Or/and....the MD5
....these need to agree. Make changes on the vtp server (if this is an
issue)..until the revision number on the server is greater than the
client. Also, make sure that you are not stopping the vlans going
through the trunk with the allowed command. And, make sure that the
trunk is up with the show interface trunk (show etherchannel summary, if
using etherchannel). HTH.
Dave Schulz,
Email: dschulz@dpsciences.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Alexei Monastyrnyi
Sent: Wednesday, October 25, 2006 3:20 AM
To: Boris Baeta
Cc: ccielab@groupstudy.com
Subject: Re: Trunking between a 3550, and a 3548xl!
and the configs are?
Boris Baeta wrote:
> I am having serious problems getting this to work. What's strange is
the
> switches can communicate, but the vlans don't seem to work. CDP
updates are
> working fine. The switches can ping each other. The proper vlans are
on both
> switches, and the trunking on both gig ports is set for dot1q
encapsulation.
> The problem is devices on vlan 3 of the first switch cannot
communicate with
> devices on vlan 3 on the second switch. I am pulling my hair out. Am I
missing
> something?
>
> Thanks!
>
>
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:06 ART