From: marc fernandez (mag08036@yahoo.com)
Date: Sun Oct 22 2006 - 03:55:49 ART
I checked the memory and processor seatings, all OK. I
can't use the monitor because the power goes off ( no
electricity to the device). It only powers up for
about 3 seconds then looses power. It worked fine for
about three weeks.
I don't know much about these devices. Could it be a
bad power supply? The power supply was loose.
-marc
PS. The 3640 had a bad memory stick. After replacing
it it had no problems.
--- Brad Ellis <brad@ccbootcamp.com> wrote:
> between this and your 3640, where are you buying
> this stuff from? ebay?
>
> anyhow, check the memory seating and processor
> seating.
>
> is anything showing up on the monitor?
>
> thanks,
> Brad Ellis
> CCIE#5796 (R&S / Security)
> CCSI#30482
> Network Learning Inc - A Cisco Sponsored
> Organization (SO)
> YES! We take Cisco Learning credits!
> brad@ccbootcamp.com
> www.ccbootcamp.com (Cisco Training and Advanced
> Technology Rental Racks)
> Voice: 702-968-5100
> FAX: 702-446-8012
> ----- Original Message -----
> From: "marc fernandez" <mag08036@yahoo.com>
> To: <ccielab@groupstudy.com>
> Sent: Saturday, October 21, 2006 9:58 PM
> Subject: IDS 4210 won't power up [bcc][faked-from]
>
>
> > When I plug the IDS 4210 it starts to power up all
> > lights turn green then it turns off automatically.
> Has
> > anyone had this issue before? Any ideas on what
> may be
> > causing this?
> >
> > -marc
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Tired of spam? Yahoo! Mail has the best spam
> protection around
> > http://mail.yahoo.com
> >
> >
>
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:06 ART