From: Victor Cappuccio (cvictor@protokolgroup.com)
Date: Sat Oct 21 2006 - 00:25:41 ART
What if R3 is a DCE?
I had a problem with that high value, so I would lower it instead just to
test
-----Mensaje original-----
De: nobody@groupstudy.com [mailto:nobody@groupstudy.com] En nombre de
CharlesB
Enviado el: Viernes, 20 de Octubre de 2006 11:07 p.m.
Para: Duane Fletcher; ccielab@groupstudy.com
Asunto: RE: Frame Relay Issues (IE WB vol 1 version 3.00 LAB 5)
Why do you need the clock rate command there, take that out and try.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Duane Fletcher
Sent: Friday, October 20, 2006 7:27 PM
To: ccielab@groupstudy.com
Subject: Frame Relay Issues (IE WB vol 1 version 3.00 LAB 5)
Hello GS,
Can someone tell me what could cause packet loss on just one DLCI? I'm
currently working in LAB 5 in the IE workbook, and my connection from R3 to
R5 is flaking out on me. These two routers have DLCI's mapped to other
routers and I'm not seeing any packet loss on these connection. So that
leads me to believe there isn't a physical problem here. The setup is the
following, R3 maps to R5 via DLCI 305 and R5 maps to R3 via 503.
Config for R3
interface Serial0/0
ip address 162.1.0.3 255.255.255.0
encapsulation frame-relay
clock rate 2000000
frame-relay map ip 162.1.0.2 302 broadcast
frame-relay map ip 162.1.0.4 304 broadcast
frame-relay map ip 162.1.0.5 305 broadcast
no frame-relay inverse-arp
Config for R5
interface Serial0/0
ip address 162.1.0.5 255.255.255.0
encapsulation frame-relay
frame-relay map ip 162.1.0.2 504
frame-relay map ip 162.1.0.3 503 broadcast
frame-relay map ip 162.1.0.4 504 broadcast
no frame-relay inverse-arp
Here's what I'm seeing when I try to ping across the link.
Rack1R5#ping 162.1.0.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 162.1.0.3, timeout is 2 seconds:
.!.!.
Success rate is 40 percent (2/5), round-trip min/avg/max = 28/28/28 ms
Rack1R5#ping 162.1.0.4 <------- pings look good to R4 on DLCI 504
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 162.1.0.4 , timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 28/31/32 ms
Thanks,
Duane
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:06 ART