From: Scott Morris (swm@emanon.com)
Date: Sun Oct 15 2006 - 00:14:57 ART
Well, assuming that you really DID want to delete that interface, why would
you not save the config prior to rebooting?
The config will show in a (deleted) state until reload, so that part of the
config, even if you delete, then save, then reload... Will actually be
gone.
HTH,
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
#153, CISSP, et al.
CCSI/JNCI-M/JNCI-J
IPExpert VP - Curriculum Development
IPExpert Sr. Technical Instructor
smorris@ipexpert.com
http://www.ipexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Tandou Mohamed
Sent: Saturday, October 14, 2006 9:17 PM
To: ccielab@groupstudy.com
Subject: Delete frame relay interface
Hello everyone,
can someone show how to deleted sub interface from a router.
i configure a frame subinterface, when i tried to delete it goes away and
when i do show ip int brief it still there. this message i am getting below:
R2#confi t
Enter configuration commands, one per line. End with CNTL/Z.
R2(config)#no interface Serial0.25 point-to-point Not all config may be
removed and may reappear after reactivating the sub-interface
R2(config)#int s0.25 multipoint
% Warning: cannot change link type
R2(config-subif)#no interface Serial0.25 point-to-point Not all config may
be removed and may reappear after reactivating the sub-interface
R2(config)#^Z R2#
How do i go around this whithout reloading the router if the config is not
saved.
thanks,
TM
---------------------------------
How low will we go? Check out Yahoo! Messengers low PC-to-Phone call
rates.
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:05 ART