From: Curt Gregg \(cugregg\) (cugregg@cisco.com)
Date: Sat Oct 14 2006 - 10:39:29 ART
Deleted state indicates that no LMI is being received from the Frame
Relay switch.
Check your LMI type and the number of messages exchanged.
Layer 1 cabling, Layer 2...
Curt
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Andy
Sent: Friday, October 13, 2006 6:53 AM
To: Group Study (E-mail)
Subject: Frame relay deleted dlcis
Hi
under what circumstances would I see a deleted dlci on my router when
using the sh fram pvc command.
I know if I configure a dlci locally (using fram map or fram int-dlci
cmd) then I get a deleted dlci if this dlci is not on the frs, ie I am
asking the frs to resolve via inverse arp a dlci it has no knowledge of
therefore I get deleted message. But if I remove all locally configed
dlcis I still see deleted dlci under sh fram pvc, even after a reload.
Why?
And as a follow up, when asked to use inverse-arp and only map the app
dlci, should I do a "no fram inver-arp XXX" where XXX is the active
(other than the one I need) , inactive and deleted DLCI, or is this over
configuration.
-A
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:05 ART