From: RalF ... (routeflap@gmail.com)
Date: Fri Oct 13 2006 - 09:09:28 ART
Hi,
you can check using show frame-relay pvc,
Reading inside the output you can determine:
PVC is Static ??
PVC is Active and Used??
or Deleted and Used ??
or InActive and Used ??
Status of the PVC. The DCE device reports the status, and the DTE device
receives the status. When you disable the Local Management Interface (LMI)
mechanism on the interface (by using the *no keepalive* command), the PVC
status is STATIC. Otherwise, the PVC status is exchanged using the LMI
protocol:
STATICLMI is disabled on the interface.
ACTIVE The PVC is operational and can transmit packets.
INACTIVEThe PVC is configured, but down.
DELETEDThe PVC is not present (DTE device only), which means that no
status is received from the LMI protocol.
Many combinatios to show u where is the problem going..
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120l
imit/120s/120s12/12sfrsdg.htm
On 10/12/06, chris <iannaconec@optonline.net> wrote:
>
> Does anyone have an idea as to the following ?
> I have a frame relay spoke and hub with only one IP address
> rest is DLCI - show frame map says everybody is active
> How else would i verify it - Ping lets me see any loss and go from
> any source i choose
> Can i somehow get that functionality here
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
--Thanks RalF
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:05 ART