From: STEELFIN (steelfin@gmail.com)
Date: Thu Oct 12 2006 - 16:59:26 ART
Hi
Is the "no ip pim dm-fallback" command used with sparse mode ? All of the
documentation I read state that it is a command and should be entered on all
sparse-mode routers to prevent fallback to dense mode in the event of RP
failure.
I am unable to enter this command :
ROM: System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-ADVENTERPRISEK9-M), Version 12.3(20), RELEASE
SOFTWARE (fc2)
R2(config)#no ip pim ?
accept-register Registers accept filter
accept-rp RP accept filter
autorp Configure AutoRP global operations
bidir-enable Enable Bidir-PIM
bsr-candidate Candidate bootstrap router (candidate BSR)
log-neighbor-changes Log PIM neighbor up/down and DR changes
register-rate-limit Rate limit for PIM data registers
register-source Source address for PIM Register
rp-address PIM RP-address (Rendezvous Point)
rp-announce-filter Auto-RP announce message filter
rp-candidate To be a PIMv2 RP candidate
send-rp-announce Auto-RP send RP announcement
send-rp-discovery Auto-RP send RP discovery message (as RP-mapping
agent)
spt-threshold Source-tree switching threshold
ssm Configure Source Specific Multicast
state-refresh PIM DM State-Refresh configuration
vrf Select VPN Routing/Forwarding instance
Is this command no longer available?
Thank you
SF
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:05 ART