From: Naveed Khan (naveed_k@hotmail.com)
Date: Tue Oct 10 2006 - 12:31:16 ART
I got it Thankx..
Naveed
----- Original Message -----
From: "Kulcsar Andras Benjamin" <Kulcsar.Andras@kfki-lnx.hu>
To: "Naveed Khan" <naveed_k@hotmail.com>; <ccielab@groupstudy.com>
Sent: Tuesday, October 10, 2006 11:11 AM
Subject: RE: fallback bridge
Hello Naveed,
Fallback bridging does not work for IPv4 traffic.
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225sec/3550scg/swfallbk.htm#wp1038531
Fallback Bridging Configuration Guidelines
A maximum of 31 bridge groups can be configured on the switch.
An interface (an SVI or routed port) can be a member of only one bridge
group.
Use a bridge group for each separately bridged (topologically distinct)
network connected to the switch.
All protocols except IP (Version 4 and Version 6), Address Resolution
Protocol (ARP), reverse ARP (RARP), LOOPBACK, and Frame Relay ARP are
fallback bridged.
Best regards,
Andras
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Naveed Khan
Sent: Tuesday, October 10, 2006 4:57 PM
To: ccielab@groupstudy.com
Subject: fallback bridge
Hi,
Fallback bridge doesn't work. I configure a virtual interface and routed
port.
-----------------------------------------------------------------------------
----------------------------------
interface Vlan11
ip address 2.2.10.7 255.255.255.0
bridge-group 1
!
bridge 1 protocol vlan-bridge
!
int fa0/2
no sw
bridge-group 1
!
Rack1R2(config)#int e0/0
Rack1R2(config-if)#ip add 2.2.10.2 255.255.255.0
Rack1SW1#sh bridge
Br Group Mac Address State Type Ports
-------- ----------- ----- ---- -----
1 0007.856c.48c0 Forward DYNAMIC Fa0/2
-----------------------------------------------------------------------------
---------------------------------
when I try to ping ip each other no reply comes. pls let me know where I am
doing mistake.
Naveed
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:04 ART