From: msaeed@uaeu.ac.ae
Date: Fri Sep 29 2006 - 20:16:03 ART
Very interesting:):) Thank you.....
Mohammad Zahid Saeed
----- Original Message -----
From: Brian Dennis <bdennis@internetworkexpert.com>
Date: Friday, September 29, 2006 5:30 pm
Subject: RE: Backup Interface of a Subinterface IE Lab 9 task 3.3
> The solution doesn't involve shutting down the subinterface.
> Check over
> the solution and in particular look over the verification as it shows
> you how to test this out.
>
> HTH,
>
> Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
> bdennis@internetworkexpert.com
>
> Internetwork Expert, Inc.
> http://www.InternetworkExpert.com
> Toll Free: 877-224-8987
> Direct: 775-745-6404 (Outside the US and Canada)
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> Behalf Of
> msaeed@uaeu.ac.ae
> Sent: Friday, September 29, 2006 2:30 PM
> To: ccielab@groupstudy.com
> Subject: Backup Interface of a Subinterface IE Lab 9 task 3.3
>
> Hi all,
>
> The requirement says that if line protocol of subinterface goes
> down the
> backup interface shall come up. Now if I apply solution given in WB,
> which is
>
> interface Serial0
> no ip address
> encapsulation frame-relay
> no frame-relay inverse-arp
> !
> interface Serial0.401 point-to-point
> ip address 148.1.0.4 255.255.255.0
> backup delay 0 300
> backup interface Serial1
> shutdown
> frame-relay interface-dlci 401
>
> and shutdown int s0.401, it puts backup interface in Disabled
> mode. But
> if I apply same config on S0, then its OK if line protocol goes
> down on
> S0, S1 comes up, but if you just shutdown S0.401 it does not bring S1
> up,
> so doesn't meet the requirement!!! Any solution???
>
> Regards,
>
> Mohammad Zahed Saeed
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:41 ART