Re: IEWB v3v1 lab 16, task 4.2 (neighbor command in ospf)

From: tonynguyenchi (tonynguyenchi.ccie@gmail.com)
Date: Wed Sep 27 2006 - 04:08:23 ART

Dear Scott,

Thanks a lot.

I have some problems with the ram. Not enought ram to run IOS 12.4 so it
produces some strange errors.

If I type:
ip ospf network point-to-multipoint
and then: ip ospf network point-to-multipoint non-broadcast
it will be fine.

Best regards,

Tony

  ----- Original Message -----
  From: Scott Ralph
  To: tonynguyenchi
  Sent: Monday, September 25, 2006 10:18 PM
  Subject: Re: IEWB v3v1 lab 16, task 4.2 (neighbor command in ospf)

  Hi Tony

  try creating a Subinterface under the actual interface and create it as a
point -to- multipoint interface.

  Regards,

  Scott

  On 9/24/06, tonynguyenchi <tonynguyenchi.ccie@gmail.com> wrote:
    Dear Group,

    R3, R4, R5 connected together over frame-relay point-to-multipoint
    non-broadcast network. But when I type:
    neighbor 154.1.0.4 cost 97
    the outpout is:
    -> OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
    networks

    In the interface connect to frame-relay, I configured:
    interface Serial0/1/0
    ip address 154.1.0.3 255.255.255.0
    ip pim sparse-mode
    encapsulation frame-relay
    ip ospf network point-to-multipoint non-broadcast
    no fair-queue
    frame-relay map ip 154.1.0.4 304
    frame-relay map ip 154.1.0.5 305
    frame-relay interface-dlci 304
    no frame-relay inverse-arp
    frame-relay lmi-type cisco

    Thanks and best regards,

    Tony

    _______________________________________________________________________
    Subscription information may be found at:
    http://www.groupstudy.com/list/CCIELab.html

  --
  Scott Ralph

This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:41 ART