From: jnkmail4eva@yahoo.com
Date: Fri Sep 22 2006 - 22:41:18 ART
I have 3 routers A, B and C
B is hub while A and C are spoke.
I am supposed to configure pim sparse mode and in case it fails dense mode should work. Also with version 2.
Right solution would be ip pim sparse-dense-mode with bsr.
I have following config
===============================================
Router A
ip multicast-routing
int s0/0
ip sparse-dense-mode
int loo0
ip sparse-dense-mode
int e0/0
ip sparse-dense-mode
ip igmp join-group 224.8.8.8
ip pim rp-candidate loop0 group-list 10
access-list 10 permit 227.0.0.0 7.255.255.255
===============================================
Router B
ip multicast-routing
int loo0
ip sparse-mode
int s0/0.148
ip sparse-dense-mode
ip pim bsr-candidate loop0 0
===============================================
Router C
ip multicast-routing
int s0/0
ip sparse-dense-mode
int loo0
ip sparse-dense-mode
ip pim rp-candidate loop0 group-list 10
access-list 10 permit 232.0.0.0 7.255.255.255
===============================================
I can ping 224.8.8.8 from Router B but not from Router C.
Any insight into where I am going wrong.
I am assuming that dense mode will work once sparse-mode fails. can someone validate the above config. Thanks.
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:41 ART