From: Jung-I Lin (easyman.lin@gmail.com)
Date: Mon Sep 18 2006 - 11:09:38 ART
Did you map the link-local ipv6 address on the fram-relay dlci of both
sides?
I usually forget about this, and have the same situation as you mentioned.
On 17 Sep 2006 04:46:13 -0000, pankaj kumar <pankaj_mcse123@rediffmail.com>
wrote:
>
> Hello All,
> Yesterday I was practicing IPV6 over frame-relay with RIP &
> encountered uncertain problem.There are 2 routers R1 & R2 running on
> frame-relay with IPV4. Now I implemented IPV6 address on both end via use
> Site-local addressing. Now both ends pinging together as it shows
> Frame-relay connectivity over IPV6 is perfectly fine. Now I configure IPV6
> on Ethernet & loppback interfaces of both routers then configure RIP on
> same. R1 is showing all possible routes getting from R2 in its
> IPV6 routing table & the same story is on R2 IPV6 table but
> the problem is I\'m not bale ping any of the IPV6 ip from remote
> ends apart of frame-relay IP because its directly connected. Waiting
> your directions on it.Thanks,Pankaj
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Thanks Best Regards,Jung-I Lin
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:40 ART