From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Tue Sep 12 2006 - 15:48:17 ART
Here is the clock rate from the DTE site.
R1#sho contr serial 2/0
M4T: show controller:
PAS unit 0, subunit 0, f/w version 3-101, rev ID 0x2800001, version 3
idb = 0x620C06F0, ds = 0x620C1D08, ssb=0x620C20A4
Clock mux=0x0, ucmd_ctrl=0xC, port_status=0x74
Serial config=0x8, line config=0x200
maxdgram=1608, bufpool=48Kb, 96 particles
DCD=up DSR=up DTR=up RTS=up CTS=up
line state: up
cable type : V.35 DTE cable, received clockrate 64000
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
base0 registers=0x3D000000, base1 registers=0x3D002000
mxt_ds=0x6265B720, rx ring entries=47, tx ring entries=64
rxring=0x4B05A0C0, rxr shadow=0x620C6950, rx_head=4
txring=0x4B05A280, txr shadow=0x620C6BBC, tx_head=3, tx_tail=3, tx_count=0
throttled=0, enabled=0
halted=0, last halt reason=0
Microcode fatal errors=0
rx_no_eop_err=0, rx_no_stp_err=0, rx_no_eop_stp_err=0
rx_no_buf=0, rx_soft_overrun_err=0, dump_err= 0, bogus=0, mxt_flags=0xC
tx_underrun_err=0, tx_soft_underrun_err=0, tx_limited=1(2)
tx_fullring=0, tx_started=3, mxt_flush_count=0
rx_int_count=6, tx_int_count=6
invalid_state=0, jigged_sig=0, invalid_timeout=0, tx_drop=0
tx_int_err=0, rx_drop=0, timer_error=0, rts_timeout=0
invalid_rx=0, tx_lost_cts=0, cts_timeout=0, late_rx=0
R1#
R1#sho ver | in c7200-
System image file is "slot0:c7200-k4p-mz.120-32.S4.bin"
R1#
HTH,
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Hash Aminu
Sent: Tuesday, September 12, 2006 11:08 AM
To: Victor Cappuccio
Cc: ccielab@groupstudy.com
Subject: Re: The most dummy question about show controllers
Victor,
you Only See CLOCK RATE on the DCE side Period!
Hashiru Aminu
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:40 ART