From: Vazman (vazman@gmail.com)
Date: Sat Sep 02 2006 - 05:03:04 ART
You can also use dot1q and tag the native vlan traffic using the command.
Switch(config)#vlan dot1q tag native
Of course, ISL seems to be the simpler solution.
HTH
On 9/2/06, srdja blagojevic <srdja1@pexim.co.yu> wrote:
>
> Ismail,
>
> my interpretation of your task is:
>
> "All traffic sent over this trunk should be tagged with a VLAN header" =>
> use ISL encapsulation
> "Do not use Dynamic Trunking protocol over this link" => switchport
> nonegotiate
>
> interface fa0/13
> switchport trunk encapsulation isl
> switchport mode trunk
> switchport nonegotiate
>
> HTH,
> Srdja
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> ismail el-shalh
> Sent: Saturday, September 02, 2006 01:50
> To: ccielab
> Subject: RE: Mock lab 1 : TASK 1.3 (Router on a stick)
>
> The previous task states :
>
> Configure a trunk between Sw1s interface F0/13 and Sw2s interface F0/13
> All traffic sent over this trunk should be tagged with a VLAN header
> Do not use Dynamic Trunking protocol over this link
>
>
> SW2-------TRUNK--------SW1------dot1q(native 263)------R6
>
>
>
>
>
> ---------------------------------
> Do you Yahoo!?
> Everyone is raving about the all-new Yahoo! Mail.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:39 ART