From: Scott Morris (swm@emanon.com)
Date: Fri Sep 01 2006 - 10:29:33 ART
Did you change anything else? Try looking at "show ip ospf interface
s0/0.235" and what does it tell you? Or "show run int s0/0.235" to see what
may have been put in there to change things.
HTH,
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
#153, CISSP, et al.
CCSI/JNCI-M/JNCI-J
IPExpert VP - Curriculum Development
IPExpert Sr. Technical Instructor
smorris@ipexpert.com
http://www.ipexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Aamir Aziz
Sent: Friday, September 01, 2006 8:57 AM
To: ccielab@groupstudy.com
Subject: Weird problem with OSPF
HI there ppl,
I have a hub and spoke environment like this R2-------R5-------R3,
R5 is the hub with s0/0.235 multipoint interface meaning by default NBMA
mode, which requires neighbor command on R5 but when i reboot R5 i get this
error :
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
networks
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
networks
and the neighbor command is no longer there in OSPF of R5, what is happening
here?? i have given ip ospf priority 0 on R2 and R3 to R5 as DR
Thanks
Aamir
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:39 ART