spanning-tree vla XX root and "sh run"

From: Bajo (bajoalex@gmail.com)
Date: Thu Aug 31 2006 - 13:08:31 ART

• Next message: chris: "switches"
• Previous message: Victor Cappuccio: "RE: OSPF using neighbour command over NBMA question"
• Next in thread: sabrina pittarel: "Re: spanning-tree vla XX root and "sh run""
• Maybe reply: sabrina pittarel: "Re: spanning-tree vla XX root and "sh run""
• Maybe reply: Bajo: "Re: spanning-tree vla XX root and "sh run""
• Maybe reply: Victor Cappuccio: "RE: spanning-tree vla XX root and "sh run""
• Maybe reply: Bajo: "Re: spanning-tree vla XX root and "sh run""
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi GS,

Is it an IOS bug that the "sh run | in spannin" will NOT show the
spanning-tree vlan XXXX root config?

I know I can check if the config works by doing "sh spann vla XXXX"

Check this out:

CAT1) conf t
CAT1(config)#spann vl 16 root pri
CAT1(config)#end

CAT1#sh run | in spann
spanning-tree mode pvst
spanning-tree extend system-id
spanning-tree vlan 16 priority 24576
 spanning-tree vlan 16 port-priority 32
 spanning-tree vlan 16 port-priority 16

CAT1#sh ver
Cisco Internetwork Operating System Software
IOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(20)EA1a, RELEASE
SOFTWARE (fc1)

-- 
Kind Regards,
Bajo

• Next message: chris: "switches"
• Previous message: Victor Cappuccio: "RE: OSPF using neighbour command over NBMA question"
• Next in thread: sabrina pittarel: "Re: spanning-tree vla XX root and "sh run""
• Maybe reply: sabrina pittarel: "Re: spanning-tree vla XX root and "sh run""
• Maybe reply: Bajo: "Re: spanning-tree vla XX root and "sh run""
• Maybe reply: Victor Cappuccio: "RE: spanning-tree vla XX root and "sh run""
• Maybe reply: Bajo: "Re: spanning-tree vla XX root and "sh run""
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:59 ART