From: Khalid Akhtar \(khakhtar\) (khakhtar@cisco.com)
Date: Thu Aug 31 2006 - 11:55:40 ART
Hi
I am getting following error message when I try to configure neighbor
command under ospf. My configuration looks like this, Any idea what is
missing here?
R2(config)#router ospf 1
R2(config-router)#neighbor 150.50.25.5
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
networks
R2(config-router)#
R2#show running-config interface serial 4/3.25
Building configuration...
Current configuration : 214 bytes
!
interface Serial4/3.25 multipoint
ip address 150.50.25.2 255.255.255.0
ip ospf network non-broadcast
ip ospf priority 100
frame-relay map ip 150.50.25.2 205
frame-relay map ip 150.50.25.5 205 broadcast
end
R2#show running-config interface serial 4/3
Building configuration...
Current configuration : 121 bytes
!
interface Serial4/3
no ip address
encapsulation frame-relay
serial restart-delay 0
no frame-relay inverse-arp
end
R2#ping 150.50.25.5
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 150.50.25.5, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/3/4 ms
R2#
R2#sh
R2#show ip os
R2#show ip ospf in
R2#show ip ospf interface ser
R2#show ip ospf interface serial 4/3.25
Serial4/3.25 is up, line protocol is up
Internet Address 150.50.25.2/24, Area 25
Process ID 1, Router ID 2.2.2.2, Network Type NON_BROADCAST, Cost: 64
Transmit Delay is 1 sec, State DR, Priority 100
Designated Router (ID) 2.2.2.2, Interface address 150.50.25.2
No backup designated router on this network
Timer intervals configured, Hello 30, Dead 120, Wait 120, Retransmit 5
oob-resync timeout 120
Hello due in 00:00:01
Supports Link-local Signaling (LLS)
Index 2/7, flood queue length 0
Next 0x0(0)/0x0(0)
Last flood scan length is 0, maximum is 0
Last flood scan time is 0 msec, maximum is 0 msec
Neighbor Count is 0, Adjacent neighbor count is 0
Suppress hello for 0 neighbor(s)
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:59 ART