From: Scott Morris (swm@emanon.com)
Date: Sat Aug 26 2006 - 08:23:52 ART
Here's an example by the way:
Router# configure terminal
Router(config)# controller t1 6/0
Router(config-controller)# channel-group 2 timeslots 3 aim 0
Router(config-controller)# exit
Router(config)# interface serial 6/0:2 <-- Note the reference to
the group number
Router(config-if)# encapsulation ppp
Router(config-if)# ip address 12.0.0.1 255.0.0.0
Router(config-if)# no shutdown
Router(config-if)# end
Check out:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hdia_r
/dia_c1h.htm#wp1129161
Scott
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
chris
Sent: Saturday, August 26, 2006 3:21 AM
To: ccielab@groupstudy.com
Subject: channel-group
Scott , Would he than be referring to QoS on the T1 - T1 is channelized by
grouping channels you are in effect doing qos , rather brilliant now that i
think of it a Qos solution with minimal drops - i want one channel for
routing updates - half the channel one way half the other for example.
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:58 ART