From: Aaron Pilcher (apilcher@itgcs.com)
Date: Wed Aug 09 2006 - 09:38:10 ART
Yes it is possible using CAR, or LLQ......the enclosed use a higher rate
than than 100/500k....
class-map match-any NoCEF1
match access-group name NoCEF1
class-map match-any NoCEF2
match access-group name NoCEF2
!
!
policy-map LIMIT
class NoCEF1
bandwidth 2000
class NoCEF2
bandwidth 1000
Interface gig0/0
service-policy output LIMIT
ip access-list extended NoCEF1
permit tcp any any
ip access-list extended NoCEF2
permit tcp any any eq ftp
permit tcp any any eq ftp-data
*********************************************
*********************************************
rate-limit output access-group 100 2000000 1500 2000 conform-action transmit
exceed-action drop
rate-limit output access-group 101 1000000 1500 2000 conform-action
transmit exceed-action drop
The ACLs 100 and 101 would, of course be something like the above (NoCEF1
and NoCEF2).
*************************************************************************
*************************************************************************
Though CEF is commonly configured with all QOS implementations, the DocCD
does not list it as a requirement for either LLQ or CAR.
-aaron
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Paul
Dardinski
Sent: Wednesday, August 09, 2006 6:44 AM
To: Cisco certification
Subject: CAR rate limiting
If required for example to limit www traffic to rate x and limit tcp
traffic to rate y, is this possible using continue via CAR?
Can anyone provide an example config for this?
Ie. limit www to 100k, tcp to 500k?
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:56 ART