From: Jordan Gottlieb (thelieber@gmail.com)
Date: Sun Aug 06 2006 - 16:48:33 ART
This should work on a 3550. But I do not believe this is a valid config on
a 2950 (since it can not route between vlans). The only layer 3
functionality on a 2950 that I know of is mgmt vlan and marking via ACL.
On 8/5/06, Aamir Aziz <aamiraz77@gmail.com> wrote:
>
> Hi there ppl,
>
> I have a question, two switches Sw1 and Sw2 (both 2950), on Sw1 i have a
> server running multicast application sending a stream to a client on Sw2,
> the requirement is that multicast packets should only be sent and received
> between the server on Sw1 and client on Sw2 so will the following
> configuration be enough:
>
> Sw1:
> Ip multicast-routing
> int fa0/1
> no switchport
> ip pim dense-mode
>
> Sw2:
> Ip multicast-routing
> int fa0/1
> no switchport
> ip pim dense-mode
>
> Do i need to put an IP on the interfaces or not?
>
> thanks
> Aamir
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:56 ART