From: Bajo (bajoalex@gmail.com)
Date: Wed Aug 02 2006 - 16:13:28 ART
Hi Srdja,
Am not sure if that is correct. Never have to configure "*
protocol-discovery"* when using NBAR in MQC. It looks it is used for
statistical data collection. The link does not use it either.
As Elias mentioned, all needed is "ip cef".
Any taker on this?
On 8/2/06, srdja blagojevic <srdja1@pexim.co.yu> wrote:
>
> Chris,
>
> you have to enable ip nbar protocol-discovery in order to use NBAR in MQC.
> Here is useful link:
>
>
>
> http://www.cisco.com/en/US/products/ps6441/products_configuration_guide_chap
> ter09186a008064fb52.html#wp1043332
>
> HTH,
> Srdja
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Guzman, Chris
> Sent: Wednesday, August 02, 2006 19:16
> To: ccielab@groupstudy.com
> Subject: NBAR and MQC
>
> Is it necessary to enable NBAR on the interface using the ip nbar
> protocol-discovery command in order to use NBAR to as match criteria in a
> class map for a MQC policy
>
>
>
> class qos1
>
> match protocol ftp
>
>
>
> In other words, will the match criteria work If I don't NOT have ip nbar
> protocol-discovery enabled on the interface.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Kind Regards,Bajo
This archive was generated by hypermail 2.1.4 : Fri Sep 01 2006 - 15:41:55 ART