From: Chris Lewis (chrlewiscsco@gmail.com)
Date: Fri Jul 07 2006 - 17:46:34 ART
There are lots of restrictions, look at
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225see/scg/swuncli.htm
on ingress what you can do is set the internal DSCP value based off
precedence, dscp or cos, then on egress, you can set those values based off
internal DSCP and in teh middle your QoS configuration will control how teh
internal DSCP value changes.
Chris
On 7/7/06, Sami <sy1977@gmail.com> wrote:
>
> Group,
>
> I am trying to match traffic based on VLAN and set IP precedence , looks
> like it doesn't work
>
> Is there any restriction for MQC on 3550 ?
>
> SW1(config-if)#service-policy output CS5
> QoS: match class-map must follow match vlan in class-map TEST.
> QoS: Policy map CS5 failed vlan check
> Service Policy attachment failed
> SW1(config-if)#
> 10:22:54: %QM-4-NOT_SUPPORTED: Action 'set' is not supported for a
> policymap
> attached to output side.
> 10:22:54: %QM-4-MATCH_NOT_SUPPORTED: Match type is not supported in
> classmap
> TEST
> SW1(config-if)#service-policy inpu
> SW1(config-if)#service-policy input CS%
> policy map CS% not configured
> SW1(config-if)#service-policy input CS5
> QoS: match class-map must follow match vlan in class-map TEST.
> QoS: Policy map CS5 failed vlan check
> Service Policy attachment failed
> SW1(config-if)#
> 10:23:11: %QM-4-MATCH_NOT_SUPPORTED: Match type is not supported in
> classmap
> TEST
> SW1(config-if)#
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Aug 01 2006 - 07:13:47 ART