From: brady.brewer@emersonnetworkpower.com
Date: Fri Jun 30 2006 - 12:38:36 ART
Can someone point me in the right direction in terms of understanding
the commands that actually emulate a frame-relay switch in the Cisco IOS
code.
I am attempting to setup my own home lab and its not very clear when
attempting to setup a multipoint frame cloud , how to actually configure
it on the Cisco router.
Command.
Interface serial1
Frame-relay route (assuming this is the local DLCI, i.e. programmed on
the closet router, for instance 200) route interface serial4 405
(terminating DLCI)
My question is how do you setup a fully meshed environment . For
instance, the local DLCI number above would need to be duplicated to
come up with the environment of a fully meshed network.
However, I know this is a wrong perception on my part because the Cisco
software will not allow for duplicate input DLCI's to be programmed.
Can some explain to me how this is accomplished on the router emulating
a Frame-Switch
So that a Hub router would have
Router ------- PVC 200 ------------------- 405
------- PVC 200 ----------------- 502
Thanks.
Brady-
This e-mail is intended only for the addressee named above.
As this e-mail may contain confidential or privileged information,
if you are not the named addressee, you are not authorized to
retain, read, copy or disseminate this message or any part of it.
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:34 ART