From: Ivan (ivan@iip.net)
Date: Thu Jun 22 2006 - 09:41:18 ART
You can modify distribution algorithm such way
sw3550(config)#port-channel load-balance ?
dst-ip Dst IP Addr
dst-mac Dst Mac Addr
src-dst-ip Src XOR Dst IP Addr
src-dst-mac Src XOR Dst Mac Addr
src-ip Src IP Addr
src-mac Src Mac Addr
AFAIK all of this algorithm use XOR-operation for determine outgoing port.
I think is one of reason that only 2, 4, 8 ports can be bundled.
>
> Is there anyway to use a debug to test this?
>
>
>
> When src-mac is used, load distribution based on the source and destination
> IP address is also enabled. For all IP traffic being routed, the switch
> chooses a port for transmission based on the source and destination IP
> address. Packets between two IP hosts always use the same port for packet
> transmission, but packets between any other pair of hosts might use a
> different transmission port.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
-- Ivan
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:33 ART