From: Venkataramanaiah.R (vramanaiah@gmail.com)
Date: Tue Jun 13 2006 - 15:30:30 ART
Hi guys, I just found that loopguard will trigger on all
non-designated ports, so it makes sense..
May be my fibre cable has some errors..
Regards
-Venkat
On 6/13/06, Venkataramanaiah. R <vramanaiah@gmail.com> wrote:
> Hi all,
>
> I had loopguard enabled on the uplink port of an access-switch. There
> are is no other L2 switching path from this switch to the rest of the
> network.
>
> However, i observed the port getting into loopinconsistent state.. Why
> should this happen..
>
> Shouldnt the loopguard trigger only on alternate ports..
>
> In my case, it is getting triggered on root port itself.. Any thoughts..?
>
> Regards
> -Venkat
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:32 ART