From: Sami (sy1977@gmail.com)
Date: Thu Jun 08 2006 - 10:22:40 ART
I think this is not correct..in my scenrio although spoke side is
configured as point to point subinterface and hub is configured on a
physical interface ..only hub and one spoke...if i use interface-dlci
command it doesn't work..when i use frame relay map command on hub ..it's
works...
So it's confusing...coudld someone explain which scenario interface-dlci
command is used on a physical port ???
Thanks
On 6/8/06, Ashwin Iyer <ash.iyer@gmail.com> wrote:
>
> yes,absolutely
>
> On 6/8/06, Sami < sy1977@gmail.com> wrote:
>
> > Group,
>
> Appreciate if some one can clarify this..
>
> Physical port in FR ex..s0/0/0 is a multipoint port by default , so we
> use
> frame relay map ip x.x.x.x <DLCI> broadcast keyword to reach spokes. But
> same time it also accept frame relay interface-dlci command ..as far as I
> know interface-dlci command is used only for point to point
> connection....so
> in nutshell if there is only one peer then we use interface-dlci command
> on
> physical port..if there are multiple peer then we use map command..
>
> Is my understanding correct ?
>
> Thanks
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
> --
> Ashwin R Iyer
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:32 ART