From: Leon van Dongen (l.dongen1@chello.nl)
Date: Thu Jun 08 2006 - 07:53:16 ART
Hello Eldho,
You need to create a frame-relay multilink interface to do so.
router(config)#interface mfr0
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hwan_c/ch05/h_mfr.htm
HTH
Leon
ELDHO PAUL schreef:
> Hi,
>
> While doing a frame relay config I again got confused with a question.
>
> 1. Configure multilink PPP over frame-relay.
> Connect Rx5 and Rx6 over frame relay with an authentication method
> supporting a hash (not chap or any ms-chap variant) using both PVCs. *Packets
> are to be fragmented among both links to ensure maximum link
> utilization*. *Your
> solution is not to involve IP addresses or IP unnumbered on the following
> interfaces: *
>
> *- Physical serial interfaces. *
> *- Virtual-templates *
>
> **
>
> I know that I need to make use of frame-relay fragmentation.But *"Your
> solution is not to involve IP addresses or IP unnumbered on the following
> interfaces: - Physical serial interfaces. - Virtual-templates " How do I
> acheive this?*
>
>
>
> Regards,
> Eldho.
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:32 ART