From: loke (loke14@gmail.com)
Date: Sun May 28 2006 - 14:56:31 ART
Or AS Path Prepend.
On 5/28/06, Nambi Appachigounder <nambi_gct@yahoo.co.in> wrote:
>
> You can either use MED/localpref/weight for this.
> if you are using med you need to apply the route map
> in the outbound direction in as1.
>
> otherwise in as2 you apply an inbound route map,set
> the local pref as per your wish.
>
> -nambi
> --- Krishnadas manghat <krsna83@gmail.com> wrote:
>
> > Hi All,
> > I just have a small question in BGP which i
> > came across while doing
> > a lab from doit workbook , I have the following
> > setup
> >
> >
> > R1-------R2------R3------R4
> > I I
> > ---------------------------------
> >
> >
> > R1 and R4 are in the AS 1 . R2 and R3 are in AS 2
> >
> > AS1 is pumping a network to AS2 ,Hence R2 gets the
> > same network thru R1
> > and R4
> >
> > R2 chooses route coming from the R4 as the local
> > preference is 100 .
> >
> > How do i make R2 prefer the route coming from R1
> > without using Weight and
> > Local Preference attribute and the configuration
> > should be done only on R2 .
> >
> >
> > Thanks ,
> > Kayd
> >
> >
> _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
>
>
> Send instant messages to your online friends http://in.messenger.yahoo.com
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:22 ART