From: Carlos Campos Torres \(ccampost\) (ccampost@cisco.com)
Date: Fri May 12 2006 - 11:35:55 ART
Also make sure that your reflector port is not being used as a source or
destination for RSPAN
Carlos Campos CCNP, CCDP
Associate Systems Engineer
Cisco Systems, Inc
(919) 392-6285
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Schulz, Dave
Sent: Friday, May 12, 2006 9:25 AM
To: Ivan; ccielab@groupstudy.com
Cc: Aaron Weaver
Subject: RE: rspan question
Yep, that's an easy one to miss, too.
Dave Schulz,
Email: dschulz@dpsciences.com
-----Original Message-----
From: Ivan [mailto:ivan@iip.net]
Sent: Friday, May 12, 2006 9:04 AM
To: ccielab@groupstudy.com; Schulz, Dave
Cc: Aaron Weaver
Subject: Re: rspan question
do not forget check that vlan 901 has type remote-span
> There is some great examples on the docCD. Here is one....
>
> This example shows how to clear any existing RSPAN configuration for
> session 1, configure RSPAN session 1 to monitor multiple source
> interfaces, and configure the destination RSPAN VLAN and the
> reflector-port.
>
> Switch(config)# no monitor session 1
>
> Switch(config)# monitor session 1 source interface fastethernet0/10 tx
>
> Switch(config)# monitor session 1 source interface fastethernet0/2 rx
>
> Switch(config)# monitor session 1 source interface fastethernet0/3 rx
>
> Switch(config)# monitor session 1 source interface port-channel 102 rx
>
> Switch(config)# monitor session 1 destination remote vlan 901
> reflector-port
> fastethernet0/1
>
> Switch(config)# end
>
> Check out....
>
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225see/scg/s
> wspan.htm#wp1401338
>
> HTH
>
>
> Dave Schulz,
> Email: dschulz@dpsciences.com
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Aaron Weaver
> Sent: Friday, May 12, 2006 8:20 AM
> To: ccielab@groupstudy.com
> Subject: rspan question
>
> What is the easiest way to set up RSPAN in between two switches. I
> want to monitor a switch port on one switch and sniff the output on
> the other switch. I have a trunk between the two switches.
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:21 ART