RE: what is "ingress" option do in the command monitor session

From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Fri May 12 2006 - 09:51:28 ART

• Next message: Schulz, Dave: "RE: question on BGP:: neighbor local-as !!"
• Previous message: Schulz, Dave: "RE: rspan question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Akshok -

This would be your interface that has the monitor/sniffer (receiving the
data).

So, on the remote switch...this would be the VLAN that is set up for
remote span. On the local switch, this would be the port that is doing
the monitoring (where the sniffer is connected). HTH,

Dave Schulz,
Email: dschulz@dpsciences.com

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ashok Ananda
Sent: Friday, May 12, 2006 5:05 AM
To: ccielab@groupstudy.com
Subject: what is "ingress" option do in the command monitor session 1
destination interface?

I couldn't get what exactly "ingress" option do with the command
"monitor
session 1 destination interface"? What is difference by giving this
option
or not giving?
 
Thanks,
Ashok M A

• Next message: Schulz, Dave: "RE: question on BGP:: neighbor local-as !!"
• Previous message: Schulz, Dave: "RE: rspan question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:21 ART