From: ccielab@cox.net
Date: Fri May 12 2006 - 00:07:15 ART
The ipv6 address on the ipv6 diagram for R3, lo103 shows
FEC0:0:0:B::67:1/128,
however after configuration it is enterred as FEC0::B:0:0:67:1. Why is this?
Also from R1 and R2, I have the route in the ipv6 table but cannot ping.
R2#s ipv6 ro
IPv6 Routing Table - 5 entries
Codes: C - Connected, L - Local, S - Static, R - RIP, B - BGP
U - Per-user Static route
I1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea, IS - ISIS summary
O - OSPF intra, OI - OSPF inter, OE1 - OSPF ext 1, OE2 - OSPF ext 2
ON1 - OSPF NSSA ext 1, ON2 - OSPF NSSA ext 2
L FE80::/10 [0/0]
via ::, Null0
C FEC0::A:0:0:7B:0/125 [0/0]
via ::, Serial0/0
L FEC0::A:0:0:7B:2/128 [0/0]
via ::, Serial0/0
R FEC0::B:0:0:67:1/128 [120/3]
via FE80::7B:1, Serial0/0
L FF00::/8 [0/0]
via ::, Null0
R2#
R2#ping FEC0::B:0:0:67:1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to FEC0::B:0:0:67:1, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)
R2#
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:21 ART