From: Bobby (aggiebob98@yahoo.com)
Date: Tue May 09 2006 - 11:49:52 ART
amen to that
Tony Schaffran <groupstudy@cconlinelabs.com> wrote: If you think that is annoying, wait till you get to the real lab. :)
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
CCIEin2006
Sent: Tuesday, May 09, 2006 6:48 AM
To: ccielab@groupstudy.com
Subject: Netmasterclass workbook - no switchport assignments or BGP diagram?
Hello group,
I recently purchased the Netmasterclass Doit Vol2 workbook and noticed that
my first lab was missing two pieces of information that
the Internetworkexpert workbook normally gives you:
1. The vlan table was missing the switch name and switchports. This was very
annoying because I had to look at the physical wiring diagram and create my
own vlan table.
2. A BGP diagram. This I can understand because they want you to think about
it a little but all in all wasn't too hard to figure out so it didn't real
add challenge to my lab.
I was just wondering if these were purposely omitted in order to make the
lab more challenging? I don't believe it really added value to the lab.
Otherwise I found the Netmasterclass workbook to be quite good in content.
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:21 ART