From: Tony Schaffran (groupstudy@cconlinelabs.com)
Date: Mon May 08 2006 - 10:48:19 ART
I would interpret what you have described as configure no inverse arp and
static mappings on the hub and spoke frame relay portion and use the
interface dlci command on the p-t-p config.
Could you be reading too deep into the requirements?
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com
Your #1 choice for online Cisco rack rentals.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Mike
O
Sent: Monday, May 08, 2006 6:36 AM
To: ccielab@groupstudy.com
Subject: Question clarity
I was doing a practice lab and ran into a situation.
Section 2.3 says configured frame-relay hub and spoke don't use dynamic
mapppings etc..
Section 2.4 says configure a p-t-p in the same cloud and don't use static
maps on R2 , but R2 is also configured in 2.3 so does that mean no static
maps on R2 anywhere?
Same thing happened where it said don't use ip ospf network command to
accomplish this. But in the next section says put loopbacks in with /24
which means I need to use ip ospf network p-t-p.
If this was the real lab would the proctor give me guidance or not? is each
section isolated from the other?
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:21 ART