From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Thu Apr 27 2006 - 23:51:33 GMT-3
Taylor - I would personally only change the native vlan, if the
requirements of the lab question required it. Only do what is asked,
since you don't get bonus points for extra config.
Dave Schulz,
Email: dschulz@dpsciences.com
-----Original Message-----
From: Wang, Ting (Taylor) [mailto:wangting@avaya.com]
Sent: Thursday, April 27, 2006 10:42 PM
To: Schulz, Dave; ccielab@groupstudy.com
Subject: RE: IEWB Lab6: 1.6 Configure a dot1q trunk between Sw1's F0/6
and Router's interface Fa1/0/0
Hi Dave,
Thanks for the answer. I understand the paket sent from native VLAN is
"untagged". If the untagged data received from native vlan of switch, it
may be discard by the Router instead of recieved on native vlan. Is that
a good design?
Thanks ,
Taylor
-----Original Message-----
From: Schulz, Dave [mailto:DSchulz@dpsciences.com]
Sent: Thursday, April 27, 2006 11:32 PM
To: Wang, Ting (Taylor); ccielab@groupstudy.com
Subject: RE: IEWB Lab6: 1.6 Configure a dot1q trunk between Sw1's F0/6
and Router's interface Fa1/0/0
Taylor - Unless it is specifically noted that frame should be
"untagged", you should not have to do anything with the native vlan.
However, if it is noted to make sure that frame are sent untagged over a
specific vlan, then you can use the "native" key word on the router.
Don't forget to also specify this under the vlan configuration on the
switch. HTH
Dave Schulz,
Email: dschulz@dpsciences.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Wang, Ting (Taylor)
Sent: Thursday, April 27, 2006 10:29 AM
To: ccielab@groupstudy.com
Subject: IEWB Lab6: 1.6 Configure a dot1q trunk between Sw1's F0/6 and
Router's interface Fa1/0/0
Hi Group,
The configure is quick simple as the following. Two VLAN was configured
on the R6.
My question is that if it is a valid configure for dot1q trunk on
Router, since no native VLAN is specified ? As we
know Vlan 1 is the default native VLAN for Switch, but what should be
the native vlan for Router by default?
R6:
interface FastEthernet1/0/0.6
encapsulation dot1Q 6
ip address 191.1.6.6 255.255.255.0
!
interface FastEthernet1/0/0.363
encapsulation dot1Q 363
ip address 204.12.1.6 255.255.255.0
SW1:
interface FastEthernet0/6
switchport trunk encapsulation dot1q
switchport mode trunk
Thanks,
Taylor
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:59 GMT-3