IEWB Lab6: 1.6 Configure a dot1q trunk between Sw1's F0/6 and

From: Wang, Ting \(Taylor\) (wangting@avaya.com)
Date: Thu Apr 27 2006 - 11:29:05 GMT-3

• Next message: Wang, Ting \(Taylor\): "IEWB solution on disable frame inverse-arp on Multipoint"
• Previous message: Vincent Mashburn: "RE: QOS Experts"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Group,
The configure is quick simple as the following. Two VLAN was configured
on the R6.
My question is that if it is a valid configure for dot1q trunk on
Router, since no native VLAN is specified ? As we

know Vlan 1 is the default native VLAN for Switch, but what should be
the native vlan for Router by default?

R6:
interface FastEthernet1/0/0.6
encapsulation dot1Q 6
ip address 191.1.6.6 255.255.255.0
!
interface FastEthernet1/0/0.363
encapsulation dot1Q 363
ip address 204.12.1.6 255.255.255.0

SW1:
interface FastEthernet0/6
switchport trunk encapsulation dot1q
switchport mode trunk

Thanks,
Taylor

• Next message: Wang, Ting \(Taylor\): "IEWB solution on disable frame inverse-arp on Multipoint"
• Previous message: Vincent Mashburn: "RE: QOS Experts"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:59 GMT-3