From: Schulz, Dave (DSchulz@dpsciences.com)
Date: Mon Apr 17 2006 - 11:18:03 GMT-3
You apply it directly in the access list....you must use the extended acl....
access-list 100 permit ip any any time-range WORK_HRS
interface s0/0
ip access-group 100 in
HTH,
Dave
________________________________
From: Naveed Khan [mailto:naveed_k@hotmail.com]
Sent: Mon 4/17/2006 1:13 PM
To: CCIEin2006; Schulz, Dave
Cc: Cisco certification
Subject: Re: Backup Interface
Hi
I understand that I could setup time-range but how I apply that.
Naveed
----- Original Message -----
From: CCIEin2006 <mailto:ciscocciein2006@gmail.com>
To: Schulz, Dave <mailto:DSchulz@dpsciences.com>
Cc: Naveed Khan <mailto:naveed_k@hotmail.com> ; Cisco certification
<mailto:ccielab@groupstudy.com>
Sent: Monday, April 17, 2006 7:11 AM
Subject: Re: Backup Interface
Okay, but thats more for a dialer interface, how do you apply it to a point
to point circuit?
On 4/17/06, Schulz, Dave <DSchulz@dpsciences.com> wrote:
Take a look at time-ranges applied to an ACL. HTH.
Dave
________________________________
From: nobody@groupstudy.com on behalf of Naveed Khan
Sent: Mon 4/17/2006 12:13 PM
To: Cisco certification
Subject: Backup Interface
Hello
Any clue for this scenario?
Configure RouterA and RouterB so the serial interface is not up during
working
hours of 5pm and 6am.
Naveed
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:57 GMT-3