From: Emil Patel (emilpatel@hotmail.com)
Date: Sat Apr 15 2006 - 16:52:51 GMT-3
The neighbor statement will only be required on R5. The neighbor statement
and interface level command are restricted to R2 and R1 if I read it
correct. I would set priority of the neighbor from the ospf router config.
Neighbor 1.2.2.2 pri 0
for both the neighbors so they cannot be the DR.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
CCIEin2006
Sent: Saturday, April 15, 2006 12:37 PM
To: ccielab@groupstudy.com
Subject: IE LAB 17 task 4.1 - for the Brians please
This question is for Brian Dennis or Brian McGahan but anyone else can feel
free to chime in.
Regarding IE version 3 Volume 1, Lab 17, task 4.1:
The task states to configure OSPF between R1, R2, and R5 which are connected
by a multipoint frame relay network with R5 as the hub.
The task states to NOT use the neighbor command to accomplish this and it
also states not to use any interface level commands on R1 or R2 (which rules
out changing the ospf network type on these routers).
Your solution states to use ospf network type non-broadcast and does not
include any neighbor statements.
Aren't you required to use neighbor statements when configuring
non-broadcast?
I tried your solution but adjacency is not being established across the
frame relay network.
What is the correct solution?
Thanks in advance!
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:57 GMT-3